Multitest-Dv Settings; Multitest-Dv Settings - Dv Operation; Settings: Jog Settings - Mecmesin MultiTest 1-dV Operating Manual

7.1. MultiTest-dV Settings – dV Operation
The settings listed below are for a MultiTest-dV being used in dV mode, for dV(u)
operation see 7.2.

Settings: Jog settings

Within the jog settings menu, you can configure the jog speed limits while in jog mode.
Below is a detailed breakdown of each setting and the options available for each setting.
Setting
Up Speed
Down Speed
Tension Limit
Compression Limit
Tare AFG/AFTI
MultiTest-dV Operating Manual

7. MultiTest-dV Settings

Action
Configure the jog speed in an upward motion
Configure the jog speed in a downward motion
Configure the tensile force limit while in jog mode
Configure the compressive force limit while in jog mode
Configure whether or not the AFG/AFTI is tared when
pressing the tare button in jog mode.
Range
0.1 to 1200
mm/min
0.004 to 47.24
Inch/min
0.1 to 1200
mm/min
0.004 to 47.24
Inch/min
0 to +200 N
0 to -200 N
Yes or No
Mecmesin  31