Banner DF-G1 Expert Quick Start Manual

DF-G1 Expert
™

Quick Start Guide

Advanced sensor with dual digital displays for use with plastic and glass fiber optic assemblies
For complete technical information about this product, including dimensions, accessories, and specifications, see
www.bannerengineering.com
WARNING:
• Do not use this device for personnel protection
• Using this device for personnel protection could result in serious injury or death.
• This device does not include the self-checking redundant circuitry necessary to allow its use in
personnel safety applications. A device failure or malfunction can cause either an energized (on) or de-
energized (off) output condition.
Overview
Figure 1. DF-G1 Model Features
Models
Model Outputs
DF-G1-NS-2M Single NPN
DF-G1-PS-2M Single PNP
DF-G1-KS-2M Dual outputs, 1 push-pull IO-Link and 1 PNP
(complementary outputs)
DF-G1-NS-Q5 Single NPN
DF-G1-PS-Q5 Single PNP
DF-G1-KS-Q5 Dual outputs, 1 push-pull IO-Link and 1 PNP
(complementary outputs)
DF-G1-NS-Q7 Single NPN
DF-G1-PS-Q7 Single PNP
Dual outputs, 1 push-pull IO-Link and 1 PNP
DF-G1-KS-Q7
(complementary outputs)
1
Connector options:
• A model with a QD connector requires a mating cordset .
• For 9 m cable, change the suffix 2M to 9M in the 2 m model number (example, DF-G1-NS-9M).
• For 150 mm (6 in) PVC pigtail, M8 Pico QD connector, 4-pin change the suffix 2M to Q3 in the 2 m model number (example, DF-G1-NS-Q3).
Original Document
161275 Rev. E
Dual Display Fiber Amplifier
and search for your model number. The instruction manual is p/n 161999.
1 Output LED
2 LO/DO Switch
3 RUN/PRG/ADJ Mode Switch
4 Lever Action Fiber Clamp
5 Red Signal Level
6 Green Threshold
7 +/SET/- Rocker Button
1
Connector
2 m (6.5 ft) cable, 4-wire
150 mm (6 in) PVC pigtail, M12 Euro QD connector, 4-pin
Integral M8 Pico QD connector, 4-pin
21 March 2019
161275