Fcc Compliance - Cardax Prox Mifare Series Installation Note

to secure the base.
Push the socket back into the grommet.
Push the grommet and socket back into the Prox Mifare Series (Teardrop)
reader base.
Check the tape covering the antenna wire solder joints is in position. Install the
PCB assembly into the base, ensuring the connector on the back of the PCB
assembly fits into the socket in the base. The PCB assembly should click into
place.
Fit the facia onto the base by clipping the small lip, inside the facia, over the
top edge of the base and holding the top, press the bottom of the facia down
over the base. Then insert the M3 x 16 Torx Security Screw (using an M3
Torx Post Security screwdriver) through the hole at the bottom of the facia and
into the threaded metal insert in the base to secure the facia.
Removal of the facia is a simple reversal of these steps.

FCC Compliance

For markets requiring FCC compliance, a
ferrite (part number C190977) must be
applied to the cable, with two-turns of the
cable running through it. Position the
ferrite as close to the entry point of the
reader as possible, as shown:
Part number 3E1100 R12
June 2007
5