Cardax Prox Mifare Series Installation Note page 4

mounting surface to a minimum depth of 40 mm (1 / in).
1
2
Drill two pilot holes for the fixing screws.
Run the building cabling through the base and grommet.
Fit the base to the 20 mm ( / inch) hole and secure it to the mounting surface
3
4
using two of the fixing screws provided.
Note: The surface the reader is being attached to will determine which length
screws are most appropriate from those provided.
WARNING: You must use the screws provided, taking care not to over-
tighten them. Make sure that the heads of the counter sunk screws are flush
with the top of the holes in the base, and ensure there is clearance for the screw
that closes the base and facia together.
Failure to do this, and/or using other types of screws could interfere with the
electronics.
Please note that the manufacturers warranty is voided if the electronics are
damaged as a result of the incorrect screws being used or installed incorrectly
4 Part number 3E1100 R12
June 2007