Advertisement
Quick Links
Component Checklist
Component Checklist
swing arm
assembly (x2)
16mm Cable
wrap (x2)
desk Clamp Box
possible Configurations
Component Checklist
spacedec acrobat swing arm Double can be
assembled in a number of different configurations
depending on the users requirements.
Two such examples are shown below and right.
spaCedeC aCROBaT
spacer Tube
assembly (x2)
Threaded rod
and Top Cap
(x1)
Pressure
Plate (x1)
Desk Clamp
m8 Desk Clamp
bracket (x1)
screw (x1)
arm, spacer, arm, spacer
side by side displays
Installation Instructions
Bits Box
inner Tube Post
5mm allen
Key (x1)
Mounting Fasteners
swing arm Double
Cable wrap
applicator (x1)
m8 interscrew
(x1)
washer (x1)
m8 nyloc nut (x1)
2.5mm allen
Key (x1)
m4x10mm
m4x12mm
screw (x8)
screw (x8)
arm, arm, spacer, spacer
back to back displays
Cable manager
Tube Clip (x1)
Cable Clip
(x4)
base Casting (x1)
m4x16mm
Countersunk
screw (x3)
extension
Clip (x8)
Top Cap Tool (x1)
m4x16mm
screw (x8)
Advertisement
Related Manuals for Atdec Spacedec Acrobat Swing Arm Double
Summary of Contents for Atdec Spacedec Acrobat Swing Arm Double
-
Page 1: Installation Instructions
(x8) screw (x8) screw (x8) possible Configurations Component Checklist spacedec acrobat swing arm Double can be assembled in a number of different configurations depending on the users requirements. Two such examples are shown below and right. arm, arm, spacer, spacer... - Page 2 Component Checklist Check you have received all parts against the Component Checklist on the previous page. assemble the arm B.2. assemble B.1. disassemble the Tube assembly swing arm assembly the swing arm You will need to disassemble the Tube assembly (x2) assemble the swing arm in before assembling the swing arm...
- Page 3 Mounting Options Continued C.2. Bolt Through C.2.1. drill Mounting Hole Top Cap Tool Drill a 13mm (½”) hole in your work surface at the desired location for your arm. Threaded rod C.2.2. Install as shown base Casting 13mm ( 1 / 2 ”) Hole insert the m8 interscrew up through the hole in the work surface.
- Page 4 Installation Complete as lCD manufacturers are constantly releasing new monitor models, atdec does not accept responsibility if the mounting hole pattern does not comply with the international Vesa standards. Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 08.11.07...
Need help?
Do you have a question about the Spacedec Acrobat Swing Arm Double and is the answer not in the manual?
Questions and answers