7471 – hilips DE
Up to 5 handsets can be registered to one base station.Additional handsets must be
registered to the base unit before you can use them.Your DECT 522 handset can also
be registered to a total of 4 bases.You can then select the base you want to use. For
example, one at work and another at home.
The instructions below apply specifically to your Philips DECT 522 handset. If you
wish to register another manufacturer's handset, the instructions may vary. In this
case, please refer to the manufacturer of the additional handset.
The system PIN is required before you can register or unregister handsets.
The default PIN is 0000.
Register a handset to a base
1
Press and hold the
The base station is able to accept registration from a handset within 60 seconds.
If no key is pressed within 10 seconds, the registration procedure will be aborted.
2
At the handset, press Menu the scroll
3
Press Select again to choose
4
Scroll
or
5
Enter the system PIN (original setting 0000) and press OK to start registration.
If the base is found and the PIN is correct, the unused handset numbers will be shown
and you can select a handset number by entering the number directly.
If the PIN is incorrect,
returns to standby mode.
A long confirmation tone is emitted to indicate successful registration and the screen
Handset Registere
displays
If the registration fails, the display shows
Try repeating the registration process.
If registration is unsuccessful make sure that there are not 5 handsets already
registered to the base. If there are, you must unregister one of the handsets in
order to register the new one.
522-UG_3111-285-31161-(GB).indd
39
CT 522 –
3111-285-31161-
Registration
button on the base station for 3 seconds.
Registration
to
Register Handset
and press Select.
Base
to select the
Incorrect System PIN!
d before returning to standby mode.
Registration Unsuccessful!
B) – 1
14.06.06
and press Select.
.
will be displayed and the handset
.
EN
39
14/6/06
17:02:5
Need help?
Do you have a question about the DECT 522 and is the answer not in the manual?