Install Tip And Guard On Gun - Graco Project Painter Plus 257025 Operation Manual

Setup
11. Transfer suction tube to paint pail and submerge
suction tube in paint.
12. Turn power switch ON.
ti5580a
13. When you see paint coming out of prime tube:
a. Point gun into waste pail.
b. Unlock gun trigger lock.
c. Pull and hold gun trigger.
d. Lower Prime/Spray valve to SPRAY.
14. Continue to trigger gun into waste pail until you see
only paint coming out of gun.
15. Release trigger. Engage trigger lock.
ti8908a
16. Transfer prime tube to paint pail and clip prime tube
to suction tube.
3A0248C
PAINT
ti14963a
ti8909a
ti13960a
• Motor stopping indicates pump and hose are
primed with paint.
• If motor continues to run the sprayer is not
properly primed. To reprime repeat step 8.

Install Tip and Guard on Gun

1. Engage trigger lock.
ti8908a
2. Verify tip and guard parts are assembled in order
shown.
retaining nut
guard
tip
Use tip to align seat
in guard
ti12966a
3. Screw tip and guard assembly on gun. Tighten
retaining nut.
black rubber gasket and
metal seat
ti12969a
Tip must be pushed
all the way into guard
ti12961a
ti1270a
17