Siemens SINAMICS BOP-2 Operating Instructions Manual page 40

Setup
Finish
Confirms the end of the commissioning process. The
Inverter will perform a motor calculation change all the
relevent parameters within the Control Module
1. Press
2. Using the
3. Press
Busy
The display during the process of changing the
parameter information of the Inverter will display
"BUSY".
Done
When the commissioning process is completed, the
BOP-2 will display "DONE". If a problem has occured or
there has been an interruption to the final process then
the BOP-2 will display "FAILURE". Should this happen,
the Inverter is to be considered unstable and the reason
for the failure should be investigated and the
commissioning process restarted.
40
to modify the parameter value.
and keys to select Yes or No.
to confirm the selection and complete the
commissioning process.
MONITORING MONITORING
PARAMETER PARAMETER
MONITORING MONITORING
FINISH
PARAMETER PARAMETER
MONITORING MONITORING
- BUSY -
PARAMETER PARAMETER
MONITORING MONITORING
- DONE -
PARAMETER PARAMETER
Basic Operator Panel 2 (BOP-2)
Operating Instructions, 2010-03-01, A5E02778927A AB
CONTROL CONTROL DIAGNOSTICS DIAGNOSTICS
FINISH
SETUP SETUP EXTRAS EXTRAS
CONTROL CONTROL DIAGNOSTICS DIAGNOSTICS
YES
SETUP SETUP EXTRAS EXTRAS
CONTROL CONTROL DIAGNOSTICS DIAGNOSTICS
SETUP SETUP EXTRAS EXTRAS
CONTROL CONTROL DIAGNOSTICS DIAGNOSTICS
SETUP SETUP EXTRAS EXTRAS