Fcc Compliance; General Description - Motorola MVME760 User Manual

FCC Compliance

The MVME760 module was tested in an FCC-compliant chassis,
and meets the requirements for Class A equipment. FCC
compliance was achieved under the following conditions:
1. Shielded cables on all external I/O ports.
2. Cable shields connected to earth ground via metal shell
3. Conductive chassis rails connected to earth ground. This
4. Front panel screws properly tightened.
For minimum RF emissions, it is essential that the conditions above
be implemented; failure to do so could compromise the FCC
compliance of the equipment containing the modules.

General Description

The MVME760 Transition Module provides the interface between
standard Ethernet, Parallel Port, and the Serial Port connectors and
the Host board P2 connector. The Ethernet and Parallel Ports
contain passive circuitry only. The I/O controllers themselves
reside in the host board. The Serial Ports contain active circuitry, to
provide multiplexing and buffering functions (reference Figure 3-1,
MVME760 Transition Module Block Diagram). The multiplexing
function is transparent to the user. Two 60-pin headers are
provided to support existing MCG Serial Interface Modules.
Currently, there are four types of Serial Interface modules available
as shown in Table 1-2:
connectors bonded to a conductive module front panel.
provides the path for connecting shields to earth ground.
General Information
1-3
1