Using Multicast Paging - Yealink SIP-T41S User Manual

Select the desired channel to listen from the pull-down list of Channel.
6.
Click Confirm.
7.
The priorities of listening addresses are predefined: 1 with the highest priority, 31 with the lowest.
Note
Multicast listening addresses are configurable via web user interface only.

Using Multicast Paging

To send RTP stream when the receiver's phone is idle:
Press Menu->Features->Paging List.
1.
Highlight the desired paging group.
2.
Press the Paging soft key.
3.
The phone sends RTP to a preconfigured multicast address (IP: Port).
Both the sender's and receiver's phones play a warning tone and the receiver automatically answers
the multicast RTP session in the speakerphone mode.
You can do the following during paging:
To place the current multicast RTP session on hold, press the Hold soft key.

The sender's phone places the multicast RTP session on hold and receiver's phone releases the
session.
To resume the held multicast RTP session, press the Resume soft key.
The multicast RTP session is established again.
To end the multicast RTP session, press the End Call soft key.

Call Features
75