Trouble Shooter And Service - Electrolux TW L4 E User Manual

TROUBLE SHOOTER AND SERVICE

TROUBLESHOOTING
1)
Problem
The tumble dryer is not connected to
mains supply.
The loading door is opened.
The tumble
dryer does The On/Off button was not pushed.
not operate.
The Start/Pause button was not push-
ed.
The appliance is in the standby mode.
Incorrect programme selection.
The filter is clogged.
The condenser is clogged.
Unsatisfactory
Too high volume of the load.
drying results.
The airflow grill is clogged.
Dirt on the inner surface of the drum.
Too high water hardness.
The filter not locked in the position.
The door
does not
The laundry is locked between the door
close.
and the seal.
You try to change the programme or the
function after the start of the cycle.
Err (Error) on
The function you try to activate is not
the display.
applicable with the selected pro-
gramme.
Abnormally
The time to end is calculated on the ba-
elapsing time
sis of the volume and dampness of the
on the dis-
laundry.
play.
Programme
The water container is full.
inactive.
To small laundry volume.
Drying cycle
too short.
The laundry is too much dried.
The filter is clogged.
Too high volume of the load.
Drying cycle
The laundry not spun sufficiently.
5)
too long
Very high room temperature - this is not
the appliance malfunction.
1) If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on. Make a selection of the
new programme. Push the Start/Pause button. Does not operate? - contact the service centre and give the error
code.
2) follow the programme description — see PROGRAMMES chapter
Possible cause Remedy
Connect in at mains socket. Check fuse
in fuse box (domestic installation).
Close the loading door.
Push the On/Off button.
Push the Start/Pause button.
Push the On/Off button.
Do the selection of the applicable pro-
2)
gramme.
3)
Clean the filter.
Clean the condenser.
Obey the maximum load volume.
Clean the airflow grill in the bottom of
the appliance.
Clean the inner surface of the drum.
Set applicable water hardness
Put the filter in the correct position.
Put the load correctly in the drum.
Turn the tumble dryer off and on. Make
the new selection.
Turn the tumble dryer off and on. Make
the new selection.
The automatic procedure — this is not
the appliance malfunction.
Drain the water container
Start/Pause button.
Do the selection of time programme.
Do the selection of time programme or
higher drying level (e.g. Extra Dry )
Clean the filter.
Obey the maximum load volume.
Spin correctly the laundry.
If possible, lower the room temperature.
electrolux 39
3)
4)
.
3)
, push the