Care And Cleaning - Electrolux TW L4 E User Manual

2. Push at the same time the Anticrease
(Knitterschutz) and Time Drying (Zeit-
wahl) buttons and hold down until one
of the these symbols go into view on
the display:
–
low conductivity <300 μS/
cm
–
moderate conductivity
300-600 μS/cm
–
high conductivity >600 μS/
cm
3. Push the Start Pause button again and
again until you set necessary level.
4. To memorise setting push at the same
time the Anticrease (Knitterschutz) and
Time Drying (Zeitwahl) buttons.
WATER CONTAINER FULL —
INDICATION
By default the indication LED is always on.
It comes into the view at the end of the cy-

CARE AND CLEANING

CLEANING THE PRIMARY FILTER
At the end of each cycle the applicable indi-
cator (clean the primary filter) is on to tell
you that the primary filter must be cleaned.
To clean the primary filter:
cle or when the water container is full.
When you use an external equipment to
drain the container, the LED can be off.
To activate or deactivate the indication:
1. Turn the programme dial to available
programme.
2. Push at the same time the Anticrease
(Knitterschutz) and Delay Start (Zeitvor-
wahl) buttons and hold down until you
see the correct setting:
– the LED is off and the symbol
goes into the view - The LED
is permanently off
– the LED is on and the symbol
goes into the view - The LED
is activated
The filter collects the fluff. The fluff oc-
curs while the cloths are dried in the
tumble dryer.
1. Open the door.
2. Pull the filter.
electrolux 33