Welch Allyn Acuity Directions For Use Manual page 137

Directions for use
Permanently stop monitoring
To permanently stop monitoring a patient
1. From the monitor's Main Menu, take these
steps.
For Propaq CS and Encore monitors:
a. In the top left or right corner of the monitor, press NET OFF .
b. Turn off the monitor.
For a Micropaq monitor:
a. Press
b. Select END TELE.
c. Remove the battery from the Micropaq monitor.
For a Propaq LT monitor:
a. Press the arrow keys to underline
b. Select Acuity menu.
c. Select END TELE.
d. Turn off the monitor.
e. Select Delete & Shut Down.
For a Welch Allyn 1500 Patient Monitor:
a. Press the Standby key and select Discharge Patient.
b. Turn off the monitor.
2. Discharge the patient from Acuity System monitoring.
For instructions, see
page 134.
The monitor disconnects from the Acuity System.
The trend information for this patient is erased from the monitor.
to highlight ACUITY, and then press
The monitor disconnects from the Acuity System.
screen, and then press
The monitor disconnects from the Acuity System.
The trend information for this patient is erased from the monitor.
The patient is discharged from the Acuity System and the
monitor enters standby mode.
The trend information for this patient is erased from the monitor.
"Discharge a patient from Acuity System monitoring"
Chapter 8 Discontinue Acuity System monitoring
to select it.
at the top of the
to select it.
133
on