Diseqc 1.2 Limit Setting - SMART M1 Plus User Manual

<DiSEqC 1.2 Limit Setting>
If you have a DiSEqC 1.2 motorized system to control your satellite antenna you have
to make the following setting. First, you must select ON on DiSEqC 1.2 of LNB Setting
in the TP Configuration.<♣ Please refer to the TP Configuration section>
1. Select DiSEqC 1.2 Limit Setting of the installation.
2. You should set the East Limit and West Limit of your satellite antenna. If you use
the satellite receiver at first. Press OK button on the Change Limit item, set the
EAST/WEST Limit.
3. Select satellite you want and DiSEqC 1.2 Positioner will be set automatically.
Satellite
The Satellite shows current
name of satellite.
Go to Center
If you press OK button dish
position is moved to center
position.
ReCalculate Pos.
You can change the input data
(Satellite Position) in the
DiSEqC box.
Clear E/W Limits
Set dish position's East or
West limit, clear the limit value.
Movement
In User mode this is used to
tune the position of the motor.
In Installer mode this is used to
search for the position of a
satellite manually.
Set East/West Limit
Set dish position's East or
West limit, disable limit value.
13