Nylon Cutting Head - Makita DUR368A Instruction Manual

4
5
► 1 . Nut 2. Clamp washer 3. Cutter blade 4. Receive
washer 5. Spindle 6. Hex wrench
1. Insert the hex wrench through the hole in the tool
head to lock the shaft. Rotate the shaft until the hex
wrench is fully inserted.
2. Mount the cutter blade onto the receive washer so
that the arrows on the blade and protector are pointing
in the same direction.
1
► 1 . Arrow
3. Put the clamp washer onto the cutter blade and
then tighten the nut securely by the box wrench.
3
4
2
► 1 . Hex wrench 2. Box wrench 3. Tighten 4. Loosen
NOTE: Tightening torque : 16 - 23 N•m
4.
1
To remove the cutter blade, follow the installation proce-
dures in reverse.
2

Nylon cutting head

3
6
► 1 . Nylon cutting head 2. Receive washer 3. Spindle
1.
head to lock the shaft. Rotate the shaft until the hex
wrench is fully inserted.
2.
tighten it securely by hand.
1
3.
To remove the nylon cutting head, follow the installation
procedures in reverse.
Plastic blade
1
► 1 . Plastic blade 2. Receive washer 3. Spindle
1.
head to lock the shaft. Rotate the shaft until the hex
wrench is fully inserted.
2.
tighten it securely by hand.
3.
16 ENGLISH
Remove the hex wrench from the tool head.
NOTICE:
Be sure to use genuine Makita nylon
cutting head.
6
5
2
3
4. Hex wrench 5. Tighten 6. Loosen
Insert the hex wrench through the hole in the tool
Place the nylon cutting head onto the spindle and
Remove the hex wrench from the tool head.
NOTICE:
Be sure to use genuine Makita plastic
blade.
6
5
2
3
4. Hex wrench 5. Tighten 6. Loosen
Insert the hex wrench through the hole in the tool
Place the plastic blade onto the spindle and
Remove the hex wrench from the tool head.
1
4
1
4