Makita DUR368A Instruction Manual page 12

DUR368L
2
► 1 . Lock-off lever 2. Switch trigger
Speed adjusting
You can adjust the tool speed by tapping the main
power button. Each time you tap the main power button,
the level of speed will change.
2
► 1 . Speed indicator 2. Main power button
Speed indicator
1
1
Mode Rotation speed
High 6,500 min
Medium 5,300 min
Low 3,500 min
Automatic Torque Drive Technology
When you turn on the Automatic Torque Drive
Technology (ADT), the tool runs at optimum rotation
speed and torque for the condition of grass being cut.
To start ADT, press and hold the reverse button until the
ADT indicator turns on. After that, tap the main power
button to select the cutting tool attached to the tool.
Light the lamp beside
and plastic blade,
head.
To stop ADT, press and hold the reverse button until the
ADT indicator turns off.
1
2
4
► 1 . marking 2.
4. Main power button 5. Reverse button
Indicator
Reverse button for debris removal
-1
WARNING:
the battery cartridge before you remove entan-
gled weeds or debris which the reverse rotation
-1
function can not remove. Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
This tool has a reverse button to change the direction of
-1
rotation. It is only for removing weeds and debris entan-
gled in the tool.
To reverse the rotation, tap the reverse button and pull
the trigger when the cutting tool is stopped. The power
lamp starts blinking, and the cutting tool rotates in
reverse direction when you pull the switch trigger.
To return to regular rotation, release the trigger and wait
until the cutting tool stops.
12 ENGLISH
marking to select cutter blade
marking to select nylon cutting
marking 3. ADT indicator
Mode Cutting tool
ADT Cutter blade
(Cutter blade) Plastic blade
ADT Nylon cutting
(Nylon cutting head
head)
Switch off the tool and remove
3
5
Rotation
speed
3,500 - 6,500
-1
min
3,500 - 6,500
-1
min