Teeter Better Back Assembly & User Instructions

Assembly & User Instructions
Better Back Comfort Cushion
™
CHOKING HAZARD: Small parts - keep out of reach of children.
Compatible with the majority of Teeter Inversion Tables*, the Better Back™ Comfort Cushion provides a plush,
supportive surface for a premium inversion experience without decreasing body slide needed for decompression.
The included fastening nodes firmly secure the Comfort Cushion to the Table Bed, so you can continue your usual
inversion routine without worrying about it slipping out of place.

How to Assemble

• Locate the fastening nodes included with the Comfort Cushion and unscrew the
backing from each.
• Place the cushion onto the Table Bed aligned with the designated holes (Figure 1).
• Insert a node backing from the back of the Table Bed through the Table Bed
slot and hole in the cushion. Turn the backing perpendicular to the slot (Figure 2).
• With the other hand, fasten the node top onto the backing threads visible from
the front of the Table Bed. Twist the node clockwise to secure it into place
(Figure 3a & 3b) in one of two ways:
1. Static: If you do not want the Comfort Cushion to move with you as you invert,
tighten the node until it is snug. Do not over-tighten.
2. Responsive: If you want the Comfort Cushion to slide with you as you invert to
encourage body slide at shallower angles, tighten the node just tight enough
to keep it in place, but loose enough to move within the slot.
• Repeat the process above with the three (3) remaining fastening nodes to finish
securing the Comfort Cushion to the Table Bed.
• Be sure to replace the backings onto the nodes when the Comfort Cushion is removed.

How to Use

• Simply lean back and enjoy the added cushion and support while inverting
on your Teeter.
• The open slots in the cushion accommodate the Lumbar Bridge accessory
included with select Teeter Inversion Tables** (shown right).
• The smooth surface provides minimal friction to still allow body slide for
effective decompression.
Cleaning & Maintenance
• Spot clean using a soft, slightly damp sponge or cloth. Do not use brushes or
abrasive cleaners.
* Comfort Cushion is not compatible with the FitFlex Bed featured on 700ia & 900ia Teeter Inversion Tables.
** Lumbar Bridge is compatible with the EP-560, EP-560 Ltd., EP-860 Ltd., EP-960 Ltd., EP-970 Ltd., & NXT-S
Teeter Inversion Tables.
Made in China. Specifications subject to change without notice.
EN
© COPYRIGHT 2018; International law prohibits any copying. EP1440 0418-2

WARNING

!
Figure 1
Figure 2
Figure 3b
Figure 3a
Your inversion table may differ from
image shown. Assembly and use of the
Comfort Cushion remains the same.