Table of Contents
Advertisement
Initial operation
6.4 Error mode
If an error is encountered during or after initial operation, the control device changes into error mode. The error
code is displayed by a blinking code. In this mode it is not possible to move the door leaf.
Name
Unknown error
Self-test – Several errors
Self-test – Oscillator defective
Self-test – Motor relay defective
Self-test – Motor driver defective
Self-test – Current measurement
defective
Self-test – Motor driver fault
detection defective
Hardware – Encoder error
Hardware – Supply voltage out of
range
Memory – RAM defective
Memory – ROM defective
Memory – EEPROM defective
Table 3 – Error codes
The red and green LEDs display the error code by blinking in a special way:
First, the red LED blinks fast, then it lights up permanently for 20 seconds. The green LED blinks as many times,
as the error code which it displays. This cycle repeats every 24 seconds until the error is reset.
red
green
4 s
In this example, the error code 4 is shown (Self-test - Oscillator error).
Slido Classic 80-B eDrive Version 1.0
Description
An unknown error occurred.
The self-test detected several problems.
The self-test detected a defective main oscillator.
The self-test detected a defective motor relay.
The self-test detected a defect in the motor driver.
The current measurement is not working properly.
The motor driver fault detection is not working properly.
The encoder is defective or not connected properly.
The supply voltage is out of its operation range.
A memory defect was detected in the RAM.
A memory defect was detected in the ROM or the program
code was altered intentionally.
The parameter memory is defective.
20 s
Code
1
2
4
5
6
7
8
9
10
11
12
13
Instruction Manual
6
21/26
Advertisement
Table of Contents
