Table of Contents
Advertisement
4
Cabling
4 Cabling
4.1 Cable diagram
2
Motor
4
Usually the control device and the power supply are mounted in two neighboring flush boxes.
4.2 Cable requirements
The following specifications are minimum requirements.
For motor cabling a special cable is recommended, which fulfills the requirements. It is available from the
manufacturer.
Cable
Between motor and control device.
Between switch/actuator and control
device.
Between power supply and control
device.
Table 1 – Cable requirements
10/26
Instruction Manual
24V =
Control device
Encoder
2
24V =
Power supply
3
Line
100..240 V~
50..60 Hz
Cable type
Motor supply (24V =)
up to 20 m
20 to 50 m
Encoder
up to 50 m
optional
up to 50 m
up to 20 m
20 to 50 m
Ground, Open,
4
Close, Stop
(60 ft):
2 x 0,50 mm² (20 AWG)
(60..160 ft):
2 x 0,75 mm² (18 AWG)
(160 ft):
4 x 0,25 mm² (22 AWG)
(160 ft):
4 x 0,25 mm² (22 AWG)
(60 ft):
2 x 0,50 mm² (20 AWG)
(60..160 ft):
2 x 0,75 mm² (18 AWG)
Switch/Actuator
on-site
(optional)
Slido Classic 80-B eDrive-Version 1.10n
Advertisement
Table of Contents
