Dip Switch - Hafele Classic 80-B eDrive Instruction Manual

Initial operation

6.1.2 DIP switch

Switch
1
2
3
ON
OFF
4
5
6
7 and 8
Table 2 - DIP switch
Switch 1 Operation mode semi-automatic / automatic:
When semi-automatic mode is set the drive will not close automatically. The potentiometer
P1 is without function.
When automatic mode is set the drive closes automatically.
Dead man's control:
Switch 2
When dead man's control is activated the drive will only operate, as long as an input signal
is applied. Switch 1 is inactive, when dead man's control is selected.
Switch 3 Push & Go:
With push & go enabled the drive starts to move, as soon as the door leaf is pushed
manually.
Switch 4 Reaction on obstruction:
When reverse is set the drive stops and starts to move in the opposite direction, as soon as
an obstruction is detected. Otherwise it will stop until a new command is given. (This is only
possible in semi-automatic mode).
Switch 5 Closing speed:
By default the closing speed is slower than the opening speed. The closing speed can be
set as fast as the opening speed, by setting this switch to ON.
Switch 6 Safety stop:
When enabled, the drive will stop a short distance before its end position and will then close
with low speed. Otherwise it will stop directly in the end position.
Slido Classic 80-B eDrive Version 1.0
Description
Operation mode
Dead man's control
Push & Go
Reaction on obstruction
Closing speed
Safety stop
Setting of maximum speed
OFF ON
(default)
Semi-automatic Automatic
Disabled Enabled
Disabled Enabled
Reverse Stop
Reduced speed Full speed
Disabled Enabled
Door leaf/
7 8
Speed
Max. 80 kg
OFF OFF
18 cm/s
Max. 80 kg
ON OFF
20 cm/s
Max 50 kg
OFF ON
25 cm/s
Max. 80 kg
ON ON
15 cm/s
Instruction Manual
6
17/26