Table of Contents
Advertisement
Initial operation
6 Initial operation
After installation of the control device, an initial operation must be performed.
The following sections describe the parts of the control device, which are relevant for the initial operation. The
following chapters describe step by step, which functions must be set up and how the initial operation is done.
6.1 Configuration
The configuration is set via the potentiometer P1, the DIP switch and the reset button. The function of these
elements is described in the following sections.
Hint
Changes in configuration will take effect only when the control device changes into configuration
mode and leaves it again.
Set configuration before initial operation
Set desired parameters, while main power is off.
Perform initial operation.
For details refer to chapter Fehler! Verweisquelle konnte nicht gefunden werden.
Configuration is set during initial operation.
Slido Classic 80-B eDrive Version 1.0
Instruction Manual
6
15/26
Advertisement
Table of Contents
