Steps During Initial Operation - Hafele Classic 80-B eDrive Instruction Manual

Initial operation

6.2 Steps during initial operation

Prepare control device
 Carry out electrical connections.
 Refer to chapter 5.2
 Set configuration.
 Refer to chapter 6
Perform reset
 Switch power supply on.
 Control device in delivery status or after power cut:
Red LED blinks continuously twice with a short break of 1.5 sec.
 Press RESET for about 2 seconds.
 Red LED blinks continuosly.
 Check driving direction of motor with control keys:
When pressing OPEN, door has to open and when pressing CLOSE, door has to close.
 When driving direction is wrong:
Swap motor cables (terminals MA and MB), check driving direction again.
 Move door in a middle position by pressing and holding the control keys.
 Press RESET for about 2 seconds.
 Red LED lights up permanently,
green LED lights up during motor activity.
 Door moves in the open position,
door moves in the closed position,
door moves in the open position.
 LEDs go out.
Check functionality
 Test, if door shows desired behavior.
 In case of malfunction check electrical connections and configuration.
 For electrical connection refer to chapter 5.2
 For configuration refer to chapter 6.1
 Repeat initial operation, if necessary.
 Initial operation is completed, when function is correct.
Slido Classic 80-B eDrive Version 1.0
W A R N I N G
Moving door leaf
Danger of injury by squashing, shearing or collision, caused
by moving door leaf.
 Keep area clear during initial operation.
Instruction Manual
6
...
...
...
19/26