Mounting And Electrical Connection; Mounting In A Flush Box - Hafele Classic 80-B eDrive Instruction Manual

Mounting and electrical connection

5 Mounting and electrical connection

5.1 Mounting in a flush box

Mounting of power supply unit (PSU) in a flush box
 Put PSU in neighboring flush box.
 Pay attention to requirements of PSU manufacturer.
 Connect power line to PSU (brown and blue wires).
 Bring leads for 24 V (red and black leads) into flush box for control device.
 Power supply is mounted and ready for operation.
Mounting of control device and switch cover
 Prepare cables of power supply and motor for connection.
 Put control device in flush box.
 Carry out electrical connections.
 For details refer to chapter Fehler! Verweisquelle konnte nicht gefunden werden..
 Secure control device with two screws.
 Perform initial operation.
 For details refer to chapter Fehler! Verweisquelle konnte nicht gefunden werden..
 Place cover frame over control device.
 Plug switch through cover frame into control device.
 Control device and switch are mounted.
Switch
Figure 2 – Mounting of control device and switch
Slido Classic 80-B eDrive Version 1.0
Electric shock
Danger of dead, serious injury or property damage.
 Cabling must be done by authorized and trained
personnel only.
 Shut down main power before carrying out any work on
cabling.
Cover frame
D A N G E R
Control device
Flush box
(on site)
Instruction Manual
5
11/26