Operating From The Control Panel - DeLonghi PAC EX130 ECOREAL FEEL BK Manual

Table of Contents

Advertisement

in the wooden
in the
kickboard of a
window
French window
panel
Fit the wall flange (B1) into the hole.
Fit the air exahaust hose (B2) into the wall flange (B1) (Fig.
9)
When the hose (B2) is not connected, the drilled hole can
be closed with the flange cap (B1).
Please note: As special tools are required for installation, we
suggest you have the appliance installed by specialized person-
nel.
When installing the air conditioner, you should leave a door
slightly open little as 1 cm to guarantee correct ventilation
and room pressure.
Keep the air hose as short and free of curves as possible to
avoid constrictions.

OPERATING FROM THE CONTROL PANEL

C14
C6
C7
C8
C9
C10
C11
in the wall: you are
recommended to
insulate the section
of wall using suita-
ble insulation.
C17
C16
C15
C13
C12
DESCRIPTION OF THE CONTROL PANEL (C)
C1. ON/STAND-BY (on/off) key
C2. Function selection key MODE (air conditioner, dehumidifier,
fan)
C3. Temperature increase key
C4. Temperature decrease key
C5. Fan speed selection key (MIN/MED/MAX/AUTO)
C6. Air conditioner symbol
C7. Dehumidifyìng symbol
C8. Fan symbol
C9. ECO REAL FEEL status indicator
C10. Swing symbol
C11. Fan speed indicator
C12. SILENT symbol
C13. Alarm symbol
C14. Set temperature values, programmed on/off time
C15. Timer symbol
C16. Timer indicator
C17. Selected temperature scale indicator
CONTROL PANEL OPERATION
TURNING THE APPLIANCE ON AND OFF
Insert the plug in the socket. Two dashes appear on the display
indicating that the appliance is in stand-by.
Touch the
(C1) key to turn on the appliance.
The flap A1 will open after few seconds. When the appliance
comes on the last function set before it was shut off is activated.
C1
Please note: If start-up is not continued, after a few minutes
the display light dims in order to reduce energy consumption.
To turn the appliance off, touch the
C3
plug.
Please note: Never turn off the air conditioner by simply pulling
C4
the plug. Touch the
stand-by and wait a few minutes before pulling the plug. In this
C2
way, the appliance can perform the operating status checks..
C5
13
, key and then pull the
key in order to put your air conditioner in

Advertisement

Table of Contents
loading

Table of Contents