Section 3 Run A Job; Load Printed Roll - Primera FX1000 Operator's Manual

Section 3 Run a Job

Section 3.1: Load a Printed Roll
1. On the unwinder/supply mandrel loosen the core engagement knob and remove the
remaining portion of the previous roll, if any.
Unwinder
Knob
2. Place the new roll on the unwinder/supply mandrel. Push it back until it touches the core
stop.
3. Be sure that the edge of the media corresponds with the edge of the core. If the media is
coning in or out you will want to attempt to straighten the media on the core. If the core is
shorter than the media width, pull the roll out so that the edge of the media is even with
the core stop. If the core is wider than the media you may need to adjust the guide
collars (Section 3.6) to accommodate the altered position of the web.
4. Turn the core engagement knob clockwise to lock the roll in place.
Core Stop
9