Table of Contents
Advertisement
Additional configurations include:
Edge Waste Wrap. Wrap the edge waste on small cores on the upper mandrel and wrap
finished labels on the lower take up mandrel. This requires additional label guides (sold
separately). You must wrap both sides of edge trim on the same mandrel to maintain even
tension.
Top View
Lower Take Up
Upper Take Up
Finished Rolls
Additional Label Guides
Edge Waste
Alternating Finish Rollers. This method would prevent finished rolls from interleaving as they
are wrapping. However, if edge waste is trimmed this method would probably require a vacuum
system to remove the edge waste.
Top View
Upper Take Up
Lower Take Up
Finished Rolls
Finished Rolls
Edge waste to
vacuum system
Edge Waste to Weeder. This involves running the waste directly from the Take Up
Guide Roller to the underside of the Waste Matrix Take Up roll. This method will increase the
size of the waste matrix more quickly and can cause problems for some types of cuts that
require very even pulling force to properly pull the matrix.
19
Advertisement
Table of Contents
