Table of Contents
Advertisement
3.7 Adjust Guides
The guide collars will not generally affect the paper path. The web should not be touching the
guides. Use them only to gauge whether the web is running straight through the system.
If the web is running too close or over a guide, check the position of the input roll. It is very
likely that the roll is not pushed all the back to the stop or the labels are not even with the edge
of the core. If the labels are not even with the core loosen the core engagement knob and either
push or pull the roll so that the label edge is even with the core stop.
There are two Guide Collars on the FX1000. Use the 2mm hex wrench to adjust the
guide collars. Each guide collar as two 2mm hex set screws
Guide Collars
22
Advertisement
Table of Contents
