Table of Contents
Advertisement
If the matrix does not easily pull, manually turn unwinder to create some slack.
7. At the same time you are pulling the matrix from the liner pull the label slack through
the slitter station over the slitter rollers and under the right guide roller.
Right Guide Roller
Slitter Rollers
8. Continue pulling the labels through the slitter and winding the matrix on the matrix
mandrel until you have enough media to attach to the lower take-up mandrel.
9. Attach an empty label core to the take up mandrel and tighten the core engagement
knob.
10. Attach the media to the core.
11. Manually turn the mandrel until media is tight
Lower take-up
mandrel
11
Advertisement
Table of Contents
