Installation - Bell 36028 User Manual

CHARGE LED Indicator - Lights up steadily when paging the handset. Lights up steadily when the
handset is being charged on the base and turns off when the handset is removed from its cradle.
MSG LED Indicator - Flashes rapidly if the system has new memo message(s) and new incoming
messages(s).
PAGE Button - Allows you to locate the handset when it is not on the base, or to alert the person near the
handset.
Volume Control «/ • Button -Adjusts the base unit speaker volume level.
PLAY/STOP Button - Press to play back the incoming Mcssagc(s)(ICM) and Memo mcssage(s) or to
stop current activity.
ANS. ON/OFF- Press to activate or deactivate answer function.
REPEAT •** Button - Press to skip to the previous message during playback.
SKIP »• Button - Press to skip to the next message during playback.
ERASE Button - Press to erase a single message or all messages in order to conserve message space in ERASE Button - Press to erase a single message or all messages in order to conserve message space in
memory. memory.
Memo Button - Press to record Memo message. Memo Button - Press to record Memo message.
OGM Button - Press to record Outgoing Message(OGM). OGM Button - Press to record Outgoing Message(OGM).
TIME SET Button - Press to set the day and time stamp. TIME SET Button - Press to set the day and time stamp.
CODE Button - Press to set the password for remote operation. CODE Button - Press to set the password for remote operation.
Ring (TS/4R/2R) Switch -Allows you to select the appropriate ringing.. Ring (TS/4R/2R) Switch -Allows you to select the appropriate ringing..
TONE/PULSE Switch - A switch located on the rear of the base unit, which allows you to set the dialing TONE/PULSE Switch - A switch located on the rear of the base unit, which allows you to set the dialing
mode to either Tone dialing or Pulse(rotary) dialing. mode to either Tone dialing or Pulse(rotary) dialing.
DC 9V jack - A jack located on the rear side of the base unit used for connecting the AC adaptor to the DC 9V jack - A jack located on the rear side of the base unit used for connecting the AC adaptor to the
base unit.
base unit.
TEL LINE jack - Accepts line cord to make connection with modular type telephone outlet. TEL LINE jack - Accepts line cord to make connection with modular type telephone outlet.

INSTALLATION

INSTALLATION
CAUTION: USE ONLY THE NICKEL CADMIUM (Ni-Cd) BATTERY CAUTION: USE ONLY THE NICKEL CADMIUM (Ni-Cd) BATTERY
TYPE INCLUDED WITH THIS UNIT. USE OF OTHER BATTERY TYPES MAY CAUSE INJURIES TYPE INCLUDED WITH THIS UNIT. USE OF OTHER BATTERY TYPES MAY CAUSE INJURIES
OR DAMAGE. OR DAMAGE.
Battery Installation Battery Installation
1. 1. Remove the battery compartment cover of the handset by pressing the top of the cover and sliding it Remove the battery compartment cover of the handset by pressing the top of the cover and sliding it
down. down.
2. 2. Connect the Ni-Cd battery pack plug along the slot into the handset's battery connector as shown Connect the Ni-Cd battery pack plug along the slot into the handset's battery connector as shown
below. below.
n f\tf\^if\/i K 1