Bell 36028 User Manual page 5

91745 for repair/warranty information. The telephone company may ask you to disconnect this
equipment from the network until the problem has been corrected or you are sure that the equipment
is not malfunctioning.
8. This equipment may not be used on coin service provided by the telephone company. Connection
to party lines is subject to state tariffs.
commission for information.).
9. USOC jack type is RJ11C and the compatible jack is part 68 compliance.
NOTICE: If your home has specially wired alarm equipment connected to the telephone line, ensure the
installation of this [equipment ID] does not disable your alarm equipment. If you have questions about
what will disable alarm equipment, consult your telephone company or a qualified installer.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and, (2) his device must accept any
interference received, including interference that may cause desired operation. Privacy of
communications may not be ensured when using this phone.
Changes or modifications not expressly approved in writing by Northwestern Bell Phones may void
the user's authority to operate this equipment.
Some cordless phones operate at frequencies that may cause interference to nearby TVs and VCRs; to
minimize or prevent such interference, the base of the cordless phone should not be placed near or on
top of a TV or VCR; and, if interference is experienced, moving the cordless telephone farther away
from the TV or VCR will often reduce or eliminate the interference.
! AC ADAPTOR: Use only with Class 2 Transformer, 9VDC output,
030206A-1
(Contact your state public utility commission or corporation
500mA for base unit and 9VDC output , 200mA for
charger, center pin positive.
4