Memory Full Detection - Bell 36028 User Manual

C. ERASING OGM
I. During OGM playback, press ERASE button.

MEMORY FULL DETECTION

The memory full condition occurs:
If 15 minutes of recording time is reached, or
If 59 message (i.e. Memo, OGM, ICM) have been recorded.
If there is an incoming call, the unit will answer at the 10* ring and announce "Memory full". You can
erase any or all the messages remotely after listening to them.
NOTE: Sometimes you may fail to escape from memory full condition when erasing a short message. In
this case, you must erase more messages (at least 1 minute message).
CALL SCREENING
You can listen to the caller leave their ICM and decide if you want to answer the call.
VOX (VOICE ACTIVATED) DETECTION
During OGM, ICM or Memo recording. The 36028 uses VOX (voice activation) to conserve message
storage space. The conditions for the 36028 terminating a recording are:
Continuous silence for seven seconds.
Seven seconds after the caller hangs up.
CALLING THE 36028 FROM A TONE PHONE
NOTE: The factory preset password for remote operation is "159".
1. Call the 36028 from a tone dialing phone.
2. While the OGM is playing, enter the "*" to skip OGM play. A long beep tone will be heard. Then
enter your 3 digits password.
3. After a successful password entry , the Remote Operation function is on.
Once you have activated the Remote Operation function through a tone dialing phone to call the 36028.
The 36028 will announce the total number of new message(s) in Message (MSG) box.
According to Voice indication. The following table shows the Voice Help Menu:
Main menu
announcement
Play memos
Play messages
Play new messages
Delete all messages
To stop function
To play the
message/Played menu
Key press
3
4
5
*4
7
9
Action
Plays memos only
Plays all messages
Plays only new messages
Deletes all messages
Stop current function
To hear message menu; See
the table below
030206A-1