Programming The Memory Feature - Lancia Voyager 2015 Owner's Handbook Manual

Driver Memory Switch
Your vehicle may have been delivered
with two RKE transmitters. Only one
RKE transmitter can be linked to each
of the memory positions.
PROGRAMMING THE
MEMORY FEATURE
NOTE: To create a new memory
profile, perform the following:
1. Cycle the vehicles ignition to the
ON/RUN position (Do not start the
engine).
2. Adjust all memory profile settings
to desired preferences (i.e., driver's
seat, outside mirrors, adjustable ped-
als and radio station presets).
3. Press and release the S (Set) but-
ton on the memory switch.
126
4. Within five seconds, press and re-
lease either of the memory buttons (1)
or (2). The Electronic Vehicle Infor-
mation Center (EVIC) will display
which memory position has been set.
NOTE:
• Memory profiles can be set with-
out the vehicle in PARK, but the
vehicle must be in PARK to re-
call a memory profile.
• To set a memory profile to your
RKE transmitter, refer to "Link-
ing And Unlinking The Remote
Keyless Entry Transmitter To
Memory" in this section.
LINKING AND UNLINKING
THE REMOTE KEYLESS
ENTRY TRANSMITTER TO
MEMORY
Your RKE transmitters can be pro-
grammed to recall one of two pre-
programmed memory profiles by
pressing the UNLOCK button on the
RKE transmitter.
NOTE: Before programming your
RKE transmitters you must select
the "RKE Linked To Memory" fea-
ture through the Electronic Ve-
hicle Information Center (EVIC).
Refer to "Electronic Vehicle Infor-
mation Center (EVIC) " in "Under-
standing Your Instrument Panel"
for further information.
To program your RKE transmitters,
perform the following:
1. Cycle the vehicles ignition to the
OFF position.
2. Select a desired memory profile
(1) or (2).
NOTE: If a memory profile has
not already been set, refer to "Pro-
gramming The Memory Feature"
in this section for instructions on
how to set a memory profile.
3. Once the profile has been recalled,
press and release the SET (S) button
on the memory switch.
4. Press and release button (1) or (2)
accordingly. "Memory Profile Set" (1
or 2) will display in the instrument
cluster.