Lancia Voyager 2015 Owner's Handbook Manual page 138

HIGH/LOW BEAM SWITCH
When the headlights are turned on,
pushing the multifunction lever to-
ward the instrument panel will switch
from low beams to high beams. Pull-
ing back to the neutral position re-
turns the headlights to the low beam
operation.
FLASH-TO-PASS
You can signal another vehicle with
your headlights by lightly pulling the
multifunction lever toward you. This
will turn on the high beam headlights
until the lever is released.
AUTOMATIC HIGH BEAM
(for versions/markets,
where provided)
The Automatic High Beam system
provides increased forward lighting at
night by automating high beam con-
trol through the use of a digital cam-
era mounted on the inside rearview
mirror. This camera detects vehicle
specific light and automatically
switches from high beams to low
beams until the approaching vehicle
is out of view.
132
NOTE: Broken, muddy or ob-
structed headlights and taillights
of vehicles in the field of view will
cause headlights to remain on lon-
ger (closer to the vehicle). Also,
dirt, film and other obstructions
on the windshield or camera lens
will cause the system to function
improperly.
To Activate
1. Select "Automatic High Beams —
ON" through the EVIC. Refer to
"Electronic Vehicle Information Cen-
ter (EVIC)/Customer-Programmable
Features" in "Understanding Your In-
strument Panel" for further informa-
tion.
2. Rotate the headlight switch coun-
terclockwise to the AUTO (A) posi-
tion.
3. Push the multifunction lever away
from you to switch the headlights to
the high beam position. Refer to
"Multifunction Lever" in this section
for further information.
NOTE: This system will not acti-
vate until the vehicle is at, or
above, 40 km/h.
To Deactivate
Perform either of the following steps
to deactivate the Automatic High
Beam system.
1. Select "Automatic High Beams —
OFF" through the EVIC. Refer to
"Electronic Vehicle Information Cen-
ter (EVIC)/Customer-Programmable
Features" in "Understanding Your In-
strument Panel" for further informa-
tion.
2. Pull the multifunction lever to-
ward you to switch the headlights
from the high beam to the low beam
position.
3. Rotate the headlight switch clock-
wise from the AUTO to the on posi-
tion.