Table of Contents
Advertisement
If one of the vehicle doors is open and
the door panel switch is used to lock
the vehicle, once all open doors have
been closed the vehicle checks the in-
side and outside of the vehicle for any
valid Passive Entry RKE transmitters.
If one of the vehicle's Passive Entry
RKE transmitters is detected inside
the vehicle, and no other valid Passive
Entry RKE transmitters are detected
outside the vehicle, the Passive Entry
System automatically unlocks all ve-
hicle doors and chirps the horn three
times (on the third attempt ALL
doors will lock and the Passive Entry
RKE transmitter can be locked in the
vehicle).
To Enter The Liftgate
With a valid Passive Entry RKE
transmitter within 1.5 m of the lift-
gate, cycle the handle to open the
liftgate and pull the liftgate open with
one fluid motion.
NOTE: All doors will remain
locked when the liftgate release
handle is pushed regardless of the
driver's door unlock preference
setting ("Unlock Driver Door 1st
Press" or "Unlock All Doors 1st
Press").
To Lock The Vehicle's Doors
With one of the vehicle's Passive En-
try RKE transmitters within 1.5 m of
the driver or passenger front door
handle, push the door handle LOCK
button to lock all four doors.
Push The Door Handle Button To
Lock
Do NOT grab the door handle, when
pushing the door handle lock button.
This could unlock the door(s).
Do NOT Grab The Door Handle
When Locking
NOTE:
• After pushing the door handle
LOCK button, you must wait two
seconds before you can lock or
unlock the doors, using either
Passive Entry door handle. This
is done to allow you to check if
the vehicle is locked by pulling
the door handle, without the ve-
hicle reacting and unlocking.
• The Passive Entry system will
not operate if the RKE transmit-
ter battery is dead.
The vehicle doors can also be locked
by using the RKE transmitter lock
button or the lock button located on
the vehicle's interior door panel.
25
Advertisement
Chapters
Table of Contents
