Toyota Avalon GSX30 Series Manual page 71

INSTALLATION
D Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension
diagram. (See the body dimension diagram)
D Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the
finish.
D After welding, apply the polyurethane foam to the corresponding parts.
D After welding, apply body sealer and under-coating to the corresponding parts.
D After applying the top coat layer, apply anti-rust agent to the inside of the necked section structural weld spots.
POINT
1 Before temporarily installing the new parts, apply body sealer to the wheel arch.
HINT:
1) Apply body sealer evenly about 5mm (0.20 in.) from the flange, avoiding any oozing.
2) Apply sealer evenly, about 3 − 4 mm (0.12 − 0.16 in.) in diameter.
2 Inspect the fitting of the rear door, luggage compartment door and rear combination light, etc., before welding,
since this affects the appearance of the finish.
PART NAME
[A] Fuel Filler Opening Lid
BODY PANEL REPLACEMENT
[B] Rivets [C] Quarter Lock Pillar Reinforcement
BP-45
F22111