Toyota Avalon GSX30 Series Manual page 51

INSTALLATION
D Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension
diagram. (See the body dimension diagram)
D Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the
finish.
D After welding, apply the polyurethane foam to the corresponding parts.
D After welding, apply body sealer and under-coating to the corresponding parts.
D After applying the top coat layer, apply anti-rust agent to the inside of the necked section structural weld spots.
POINT
1 Before temporarily installing the new parts, weld the [A], [B] and [C] with standard points.
PART NAME
[A] Center Body Pillar Lower Reinforce
[C] Center Body Inner Pillar
10 mm (0.39 in.)
BODY PANEL REPLACEMENT
[B]
30 mm (1.18 in.)
Center Body Pillar Upper Reinforce
60 mm (2.36 in.) 565 mm (22.24 in.)
BP-29
F22095