Toyota Avalon GSX30 Series Manual page 47

INSTALLATION
D Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension
diagram. (See the body dimension diagram)
D Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the
finish.
D After welding, apply the polyurethane foam to the corresponding parts.
D After welding, apply body sealer and under-coating to the corresponding parts.
D After applying the top coat layer, apply anti-rust agent to the inside of the necked section structural weld spots.
POINT
1 Before temporarily installing the new parts, weld the [B], [C], [D] and [E] with standard points.
PART NAME
[B] Center Body Pillar Lower Reinforce
[D] Cowl Side Panel
10 mm (0.39 in.) 35 mm (1.38 in.)
BODY PANEL REPLACEMENT
[C] Front Body Pillar Lower Reinforce
[E] Front Body Outer Pillar
65 mm (2.56 in.)
[F] Instrument Panel To Cowl Side Bracket
170 mm (6.69 in.)
BP-25
F22091
410 mm (16.14 in.)