Chapter 2: Installation Instructions; General Installation Requirements - Frymaster FQE60U FilterQuick easyTouch Installation, Operation And Maintenance Manual

FQE60U FILTERQUICK
2.1

General Installation Requirements

Proper installation is essential for the safe, efficient, trouble-free operation of this appliance.
Qualified, licensed, and/or authorized installation or service personnel, as defined in Section 1.6
of this manual, should perform all installation and service on Frymaster equipment.
Failure to use qualified, licensed, and/or authorized installation or service personnel (as defined
in Section 1.6 of this manual) to install or otherwise service this equipment will void the
Frymaster warranty and may result in damage to the equipment or injury to personnel.
Where conflicts exist between instructions and information in this manual and local or national
codes or regulations, installation and operation shall comply with the codes or regulations in
force in the country in which the equipment is installed.
Service may be obtained by contacting your local Frymaster Authorized Servicer.
All fryers shipped without factory supplied cords and plug assemblies must be hardwired using
flexible conduit to the terminal block located on the rear of the fryer. These fryers should be
wired to NEC specifications. Hardwired units must include installation of restraint devices.
Adequate means must be provided to limit the movement of this appliance without depending
on or transmitting stress to the electrical conduit. A restraint kit is provided with the fryer. If
the restraint kit is missing contact your local Frymaster Authorized Servicer (FAS).
If this equipment is wired directly into the electrical power supply, a means for disconnection
from the supply having a contact separation of at least 3-mm in all poles must be incorporated in
the fixed wiring.
This equipment must be positioned so that the plug is accessible unless other means for
disconnection from the power supply (e.g., a circuit breaker) is provided.
If this appliance is permanently connected to fixed wiring, it must be connected by means of
copper wires having a temperature rating of not less than 167°F (75°C).
If the electrical power supply cord is damaged, it must be replaced by a Frymaster Authorized
Servicer or a similarly qualified person in order to avoid a hazard.
easyTouch
™

CHAPTER 2: INSTALLATION INSTRUCTIONS

®
SERIES ELECTRIC FRYER
NOTICE
DANGER
NOTICE
NOTICE
NOTICE
NOTICE
2-1