Chapter 2: Installation Instructions; Introduction - Frymaster FPRE117 Installation, Operation, Service, And Parts Manual

RE SERIES MARINE E

CHAPTER 2: INSTALLATION INSTRUCTIONS

2.1

Introduction

The instructions in this chapter cover all configurations of RE Series Marine Electric Fryer models
specifically configured for use aboard surface ships, including FPRE117/122 kW and FPRE217/222
kW models. The instructions do not cover and may not be used for installations ashore.
Proper installation is essential for the safe, efficient, trouble-free operation of this appliance.
Any unauthorized alteration of this equipment will void the Frymaster warranty.
All fryers shipped without factory supplied cords and plug assemblies must be
hardwired using flexible conduit to the terminal block located on the rear of the fryer.
These fryers should be wired to NEC specifications. Hardwired units must include
installation of restraint devices.
Adequate means must be provided to limit the movement of this appliance without
depending on or transmitting stress to the electrical conduit.
If this equipment is wired directly into the electrical power supply, a means for
disconnection from the supply having a contact separation of at least 3-mm in all
poles must be incorporated in the fixed wiring.
This equipment must be positioned so that the plug is accessible unless other
means for disconnection from the power supply (e.g., a circuit breaker) is provided.
If this appliance is permanently connected to fixed wiring, it must be connected by
means of copper wires having a temperature rating of not less than 167°F (75°C).
If the electrical power supply cord is damaged, it must be replaced by a Frymaster
Dean Factory Authorized Servicer technician or a similarly qualified person in order
to avoid a hazard.
This appliance must be connected to a power supply having the same voltage and
phase as specified on the rating plate located on the inside of the appliance door.
4
ELECTRIC FRYERS
NOTICE
DANGER
NOTICE
NOTICE
NOTICE
NOTICE
DANGER
2-1