Installation - IFM Electronic Efector 500 Operating Instructions Manual

P'
CP2'
CP1
P'
CP2'
CP1'
CP1
5 Installation
Before installing and removing the unit: make sure that no pressure is ap-
plied to the system� Note: If 0% is displayed and no pointer is visible, this
does not mean that no pressure is applied to the system!
The unit must only be installed in a process connection for G1 sealing
cones (e�g� ifm welding adapter, order no� E30013)�
Installation in a process connection for a G1 sealing cones
► Insert the unit (A) into the process
connection (C), push the threaded
sleeve (B) towards the internal
thread of the process connection
and lightly screw it in�
► Orientate the unit, tighten the
threaded sleeve (B) with a spanner
and ensure that the unit is correctly
oriented while doing so�
Tightening torque 20 Nm��
8
• P = measured pressure;
2
• CP1 = calibration point 1;
1
• 1 = curve of measured values at factory setting
• 2 = curve of measured values after
P
CP2
• P = measured pressure;
2
• CP1 = calibration point 1;
1
• CP2 = calibration point 2;
• 1 = curve of measured values at factory setting
• 2 = curve of measured values after
P
CP2
A
P' = modified measured value
CP2 = calibration point 2;
CP2' = modified measured value for
CP2
calibration
P' = modified measured value
CP1' = modified measured value for CP1
CP2' = modified measured value for CP2
calibration
B
C
24
34