Dataprobe iBoot-G2S Manual page 30

9.2. iBoot-G2+ CLI Syntax
Command
Control Commands
set < main | outlet | exp1 | exp2 | outlet
name > <on | off | cycle>
get outlets
get status
Device Commands
set location <20 char. max>
get location
set < main | outlet | exp1 | exp2 | outlet
name > cycle time <1-999>
get cycle
set delay <0-999>
get delay
set timeout <0-99>
get timeout
set < main | outlet | exp1 | exp2 | outlet
name > initial state <on | off | last>
get initial state
V180817w
Description
These commands are used to monitor and control the outlet.
This command controls power state. "main" or "outlet" to
control main outlet. "Exp1" or "Exp2" to control
Expansion outlets. or use programmed outlet name.
In I/O mode Exp1 an Exp2 can use open and closed
This command returns the current status of the main
and expansion outlets. The response to this command
is determined by the expansion mode setting.
Result will use programmed outlet names.
If iBoot-Exp or Power Control mode:
Main Outlet: On
Exp 1: On L (L indicated Locked to Main)
Exp 2: Off
If Independent I/O mode:
Main Outlet: On
Exp1:
Input: Open
Output: Closed
Exp2:
Input: Open
Output: Open
Set commands are available to the administrator only
This command is used to set the iBoot-G2's location ID.
this is used for LLMNR and
Displays the current location name
This command sets the cycle time in seconds on a per
outlet basis.
Displays the current cycle times for all outlets
This command sets the delay time in seconds used when
multiple outlts are controlled
Displays the delay time used between outlets
This command sets the auto logout time in minutes
Displays the current timeout
This command sets the initial state of the individual
outlets when the iBoot-G2+ is powered up or rebooted.
Displays initial state for all outlets
iBoot-G2+ / iBoot-G2S
Cloud Registration
Factory
Default
iBoot-G2P-xxxx
5
1
2
Last
Page 30