Dataprobe iBoot-G2S Manual page 10

Change the IP Address
1. Click on the row containing the iBoot-G2+ to
be set. The row will become highlighted.
2. From the menu select Set | Network Settings
3. Enter the IP Mode Static and select desired
network setting, or Enter the IP Mode DHCP
and allow the Network to assign the network
information. Click OK when done.
4. A confirmation box is displayed. Click OK to
clear the box.
Once the IP Address is set, other all other
operational features of the iBoot-G2+ can be set
up. Click on Discover again to refresh the
display, highlight the desired iBoot-G2+ and click
on Manage | Launch Browser. see Web Setup
section 7 to configure the iBoot.
The DMU can also be used to return an
iBoot-G2+ to its Factory Default condition, or to
reset an iBoot-G2+ admin password only.
Highlight an iBoot-G2+ from the display and
select Set | Factory Defaults, or Set | Admin
Password. Depending on what you want to reset.
These must also be done within the first two
minutes of powering up or reboot of the iBoot.
5.3. Other ways to set the IP Address
1. Web Browser via the Set-up Page – see Network Settings
2. Command Line Interface see iBoot-G2+ CLI Syntax
V180817w
section 9.2
iBoot-G2+ / iBoot-G2S
Enter New IP Address for iBoot
IP Address Successfully Set
section 7.3
Page 10