Advertisement
Section 4: Options & Accessories
Section 4: Options & Accessories
B3350 Ball Swivel Hitch Accessory
Refer to Figure 4-1:
Part No.
Description
315-799A
Ball Swivel Hitch Assembly
The Ball Swivel Hitch Assembly is designed for the
B3350 Kubota tractor with its 2" x 1 1/4" (5 cm x 3 cm)
straight drawbar and drawbar hitch hole located 7 3/4"
(20 cm) from end of tractor power take-off shaft.
This hitch option moves the hitch hook-up point back an
additional 6 1/4" (16 cm) from the tractor power take-off
shaft and lowers the top of the drawbar down an
additional 3/8" (9 mm). For additional information, refer to
"Drawbar Set-Up" on page 16.
Ball Swivel Hitch Installation
Refer to Figure 4-2:
1.
Insert bolt (#1A) through washer (#2A), top
mount (#3), hitch hole in drawbar (#11), and bottom
swivel mount (#4). Secure bolt (#1A) with nylock nut
(#5A). Draw nut up snug, do not tighten at this time.
2. Insert bolts (#1B) through washers (#2B), top mount
(#3), and bottom swivel mount (#4). Secure bolts
(#1B) with nylock nuts (#5B).
3. Tighten nylock nuts (#5A & #5B) to the correct torque
for a 3/4"-10 GR5 bolt. See "Torque Values Chart"
on page 52
Ball Swivel Hitch Hook-up to AFM
Refer to Figure 4-2:
1.
Make certain park jack (not shown) is attached to the
mower hitch and secured with its retaining pin.
2. Back tractor within close proximity of clevis (#12).
3. Shut tractor down before dismounting. Refer to
"Tractor Shutdown Procedure" on page 16.
4. Raise or lower park jack to align clevis (#12) slightly
above ball swivel (#13).
5. Back tractor up to mower hitch until hole in ball
swivel (#13) and clevis plates (#12 & #14) are
aligned.
6. Shut tractor down before dismounting. Refer to
"Tractor Shutdown Procedure" on page 16.
7.
Make final adjustments to the park jack as needed.
8. Insert 1" bolt (#6) through washer (#7), upper clevis
plate (#12), hitch spacer (#8), ball swivel (#13), and
lower clevis plate (#14).
9. Secure bolt (#6) with washer (#9) and nylock
nut (#10). Draw nylock nut up snug, do not torque
tight.
10. Continue with steps 8-9 on page 18.
32
AFM3011 All-Flex Grooming Mower 315-783M
Table of Contents
Drawbar
Ball Swivel Hitch Attached to B3350 Tractor Drawbar
72286
Power Take-Off Shaft
7 3/4"
(20 cm)
Figure 4-1
Hook-up to Ball Swivel Hitch
Figure 4-2
72286
6 1/4" (16 cm)
3/8" (9 mm)
3/21/19
Advertisement
