Advertisement
Section 1: Assembly & Set-up
Section 1: Assembly & Set-up
Tractor Requirements
Tractor horsepower should be within the range noted
below. Tractors outside the horsepower range must not
be used.
Horsepower rating . . . . . . . . . . . 30-55 hp (22-41 kW)
Power take-off shaft type . . . . . . . . . . 1 3/8"-6 Spline
Power take-off speed . . . . . . . . . . . . . . . . . . 540 rpm
Hitch type. . . . . . . . . . . . . . . . . . . . . . . . . . . Draw bar
Hydraulic outlet . . . . . . . . . . . . . . . One duplex outlet
Electrical outlet (See Figure 1-1) . . . Seven pin outlet
Tractor weight. . . . . . . . . . . . . . . . See Warning below
Positive drawbar hitch weight . . . . . . 500 lbs (227 kg)
Ballast requirements . . . . . . . . . . See Warning below
!
WARNING
To avoid serious injury or death:
Lightweight tractors with rear attached implements may need
weights added to the front to maintain steering control.
Consult your tractor Operator's Manual to determine proper
weight requirements and maximum weight limitations.
11640
Tractor 7-Pin Electrical Outlet
Figure 1-1
Electrical Hook-up
Refer to Figure 1-1:
The light wire harness has a round 7-pin male connector
that connects to the tractor's 7-pin electrical outlet shown
above.
Dealer Preparations
This mower has been partially assembled at the factory.
Some additional preparations will be necessary to finish
assembling the implement and to attach it to the
customer's tractor. Make sure the intended tractor
conforms to "Tractor Requirements" above and
"Drawbar Set-Up" on page 16.
An understanding of how this implement works will aid in
final assembly and setup. Read and understand the
Operator's Manual. Go through the "Pre-Assembly
Checklist" on this page. To speed up the assembly task
and make the job safer, have all needed parts and
equipment readily at hand.
3/21/19
Table of Contents
Make sure miscellaneous assembly tools are on hand:
Hammer, tape measure, and assortment of wrenches.
Have a forklift or chain hoist capable of lifting 2500 lbs
(1130 kg) and safety stands on hand.
Have a minimum of two people available during assembly.
Check to see if additional tractor weights are needed.
Check to make sure all fasteners & pins are
installed in the correct location. Refer to the Parts
Manual if unsure. NOTE: Remember location of a
part or fastener if removed. Keep parts separated.
Make sure all major components and loose parts
are shipped with the machine.
Make sure working parts move freely, bolts are
tight & cotter pins are spread.
Make sure all safety labels are correctly located
and legible. Make sure red and amber reflectors
are correctly located and visible when machine is
in transport position. Replace damaged labels.
Make sure all lights are functioning properly.
Refer to"Hook-up Transport Lights".
80-90 EP Gear Lube must be added to the
gearboxes as indicated in the "Maintenance &
Lubrication" .
Make sure transport tires are inflated to the
specified air pressure.
Make sure all wheel bolts and axle nuts are
tightened to the specified torque.
Hardware Torque Information
Refer to "Torque Values Chart" on page 52 to
determine correct torque values for common bolts. See
"Additional Torque Values" at the bottom of the chart for
exceptions to standard torque values.
Pre-Assembly Checklist
Check
AFM3011 All-Flex Grooming Mower 315-783M
Ref.
Parts
Manual
Operator's
Manual
Operator's
Manual
Page 6
Page 19
Page 42
Page 52
Page 52
15
Advertisement
