Advertisement
Section 2: Adjustments
72296
Linchpin (#4)
Insert From the Front
Approximately 3/4" Cutting Height
Minimum Cutting Height Set-up
No spacers are located below support tubes (#7 & #8)
Refer to Figure 2-3:
IMPORTANT: Slide-on spacers are 1/2" thick. Use
two 1/2" slide-on spacers at the front of the rear deck
for every 1" spacer used at the back of the rear deck.
15. Remove wire retainer pins (#10) and adjust support
stands (#11) down. Reinsert wire retainer pins. Make
sure wire retainers are caught over the pin ends.
16. Start tractor and lower mower to field position making
sure all folding cylinders are fully extended. Refer to
"Unfold Mower Decks" on page 28.
17. Back mower until support stands are vertical and rod
tubes (#8) are raised fully up.
18. Shut tractor down before dismounting. Refer to
"Tractor Shutdown Procedure" on page 16.
19. Adjust front of rear deck height to match deck height
at the back of the rear deck:
a. On the right-hand side, remove linchpin (#2).
b. Add or remove c-spacers (#3) below support tube
(#8) at groove (#9). Hold c-spacers below support
tube (#8) above the groove, turn open end of c-
spacer to align with the groove, and slide c-spacer
on or off the groove.
c. Add or remove c-spacers (#3) to groove (#9) until
the thickness of spacers (#3) below support
tube (#8) equals the thickness of spacers in
step 9.
d. Install remaining c-spacers (#3) above support
tube (#8) and secure with linchpin (#2).
e. Repeat steps b-d above on the left-hand side of
the rear deck.
20. Restart tractor and raise decks up until they are
secured with the transport locks.
3/21/19
Table of Contents
Insert From the Front
All spacers are located below support tubes (#7 & #8)
Adding & Removing C-Spacers
Figure 2-2
21. Shut tractor down before dismounting. Refer to
"Tractor Shutdown Procedure" on page 16.
22. Remove wire retainer pins (#10) and adjust support
stands (#11) up. Reinsert wire retaining pins. Make
sure wire retainers are caught over the pin ends
23. Start tractor and lower mower to field position making
sure all folding cylinders are fully extended. Refer to
"Unfold Mower Decks" on page 28.
24. Shut tractor down before dismounting. Refer to
"Tractor Shutdown Procedure" on page 16
25. Take measurements from the same location on all
three decks to make sure they are at the same cutting
heights.
26. Additional adjustments may be required after a test
run of the mower.
72298
Linchpin (#4)
Approximately 5 1/4" Cutting Height
Maximum Cutting Height Set-up
Adding & Removing C-Spacers
Figure 2-3
AFM3011 All-Flex Grooming Mower 315-783M
72297
23
Advertisement
