Advertisement
NFX150-C-S1 Network Services Platform Quick Start
Drill two holes at a distance of 11.95 in. (30.35 cm) on a plumb line from hole A and B, install the mounting screws.
c.
Insert the mounting screws only part way in, leaving about 1/4 in. (6 mm) distance between the head of the screw and the
d.
wall.
If the mounting screws are inserted in wall board with no stud behind it, you must use dry wall anchors rated to support 20 lb
3.
(9 kg). Insert the screws into wall studs wherever possible to provide added support for the chassis.
Grasp each side of the device, lift the device, and hang the brackets from the mounting screws such that the front panel of
4.
the device faces to your right or left side.
Tighten the mounting screws.
5.
Connect Power to the Device
CAUTION:
Wrap and fasten one end of the ESD grounding strap around your wrist and connect the other end to a
site ESD point.
To connect the device to the power supply:
Plug the DC connector end of the power cable into the power connector on the back of the device.
1.
Plug the AC adapter end of the power cable into an AC power outlet.
2.
Power Cable Warning (Japanese)
WARNING:
The attached power cable is only for this product. Do not use this cable for another product.
Factory-Default Settings
The NFX150 device is shipped with the following factory-default settings:
Table 1: Security Policies
Source Zone
trust
trust
Table 2: Interface Mapping
Port Label
Interface
0/0 to 0/3
heth-0-0 to heth-0-3
4
Destination Zone
trust
untrust
Virtual Interface
ge-0/0/0 to ge-0/0/3
Policy Action
permit
permit
Security Zone
DHCP State
trust
Server
IP Address
192.168.2.1/24
Copyright © 2018, Juniper Networks, Inc.
Advertisement
