Configure Hart ® Operation During Fault; Set The Time And Date - Honeywell Searchpoint Optima Plus Operating Instructions Manual

MAN0905_Issue 7_07/17
12. Commissioning using
9. Type in the new password and press Enter.
Note: Some HART handheld devices contain a default password or hold a previously used password.
®
Ensure that the desired password is typed in before pressing Enter.
10. The display shows a confirmation message, press OK.
11. Proceed to Configure HART
Setup menu.
12.3.2 Configure HART
Searchpoint Optima Plus is shipped with the Fault output current level set to < 1 mA. If the unit enters
a Fault condition, the HART
operate). The Fault output current level can be changed to 1 mA so that HART
active during a Fault condition.
1. Select Device Setup.
2. Select User Configuration.
3. Select HART During Fault.
4. Select HART ACTIVE and press Enter.
5. Press Send to send the information to Searchpoint Optima Plus.
6. Proceed to Set the Time and Date, step 3, or press Back to return to the Device Setup menu.

12.3.3 Set the Time and Date

Searchpoint Optima Plus has a real time clock, which is factory set to UK time. It can be adjusted to local
time.
1. Select Device Setup.
2. Select User Configuration.
3. Select Set Time.
4. Enter the correct time (24 hour format) and press Enter.
5. The display shows a confirmation message, press OK.
6. Select Set Date.
7. Enter the correct date (dd/mm/yyyy format) and press Enter.
8. The display shows a confirmation message, press OK.
9. Proceed to Configure Warning, Inhibit and Overrange Signal Levels, step 3, or press Back to return
to the Device Setup menu.
HART Communications
®
Operation during Fault, step 3, or press Back to return to the Device
®
Operation during Fault
®
communications will not work (HART
®
Searchpoint Optima Plus with optional HART
communications require > 1 mA to
®
54
Operating Instructions
2108M0550
communications remain
®
output
®