Honeywell Searchpoint Optima Plus Operating Instructions Manual page 23

MAN0905_Issue 7_07/17
3. Mechanical Installation
US Duct Mounting Kit – NPT Threads
Note: In order to make use of the gassing points provided, the Searchpoint Optima Plus unit must be
factory fitted with the Remote Gassing Cell (2108B0240).
Note: CSA approval only applies for duct flow rates less than 5m/s.
The duct mounting kit is assembled and installed onto a duct as below:-
1. Cut a square 6" by 6" hole in the duct wall. Drill the holes required to attach the mounting plate to the
duct wall.
2. Place the Searchpoint Optima Plus unit on the side of the mounting plate where the threaded bushes
protrude and feed the wires through the central hole.
3. Locate the unit's boss in the central hole and feed the unit's wires through the chosen cable entry on
the junction box.
Searchpoint Optima Plus with optional HART
Note: Dimensions shown
in inches.
23
output
®
Operating Instructions
2108M0550