Ricoh Pro 907 Operating Instructions And Troubleshooting page 42

2. Troubleshooting When Using the Printer Function
Problem
Edges of sheets are creased. You are using non-
The image has mottled blank
2
patches or is smudged.
Paper is fed from the
interposer tray even if neither
cover sheet nor slip sheets is
selected.
40
Cause
recommended paper.
Missing patches and
smudges are caused by
moisture leaking from the
paper.
In [PS / PDF Menu], [Alt.
Paper Size with Reduced Print
Image] is set to [Active], and
the paper specified in the
printer driver is not loaded in
any tray except the
interposer.
Solution
Use recommended paper. See
"Recommended Paper Sizes and
Types", About This Machine
• Do not install the machine in areas
that are susceptible to low
temperature.
• Use paper that has been stored
where temperature and humidity
conditions meet the limitations we
recommend. For details about the
paper storage conditions we
recommend, see "Paper Storage",
About This Machine
• Install the Optional anti-humidity
heater. For details about the anti-
humidity heater, contact your
service representative.
Load the selected paper tray with the
paper specified in the printer driver, and
then try printing again. To prevent this
error recurring, do not to set the [Paper
source tray:] to [Auto Tray Select], and
be sure to set [Alt. Paper Size with
Reduced Print Image] to [Inactive] (in
[PS / PDF Menu]). For details about this
function, see "Basic Configuration",
Printer Reference .
.
.