Ricoh Pro 907 Operating Instructions And Troubleshooting page 31

Message
"Problem with Hard Disk.
Please call service."
"Ready to print. Please go
back to the initial screen to
start printing."
"Reset Tray n correctly."
(A figure is placed at n.)
"SD Card authentication has
failed. Press [Cancel] to
cancel mode. Please call
service."
"SD card is not set correctly.
Contact the administrator."
"SDRAM module could not
be recognized."
"Selected function cannot be
used with Fold mode. Press
[Job Reset] to cancel
printing."
"Selected paper size is not
supported. Press [Job Reset]
to cancel the printing."
Cause
A hard disk error has
occurred.
The creation of offline print
data is complete. This
message appears when
printing items selected on the
[Test Print] tab.
The selected paper tray is not
installed or is installed
incorrectly.
SD card authentication has
failed.
The SD card is not inserted
correctly.
An error has occurred in the
SD RAM module.
Selected function cannot be
used with Fold mode.
An unsupported paper size
was specified for a PostScript
print job.
Messages Displayed When Using the Printer Function
Solution
Switch the machine's main power off
and then back on. If the message
persists, contact your service
representative.
Press [Exit], then press the [User Tools]
key to switch to the regular printer
screen, and then press [Online] to start
printing. For details about [Test Print],
see "Basic Configuration", Printer
Reference .
Install the paper tray correctly, or press
[Job Reset] to cancel the print job.
Contact your service representative.
Contact the administrator.
Contact your service representative.
Press [Job Reset] to cancel the print job.
For details about the fold function, see
"Advanced Printing", Printer Reference
.
Press [Job Reset] to cancel the print job,
and then set the paper size correctly.
2
29